Specifications; Important Safety Instructions - Makita AN621 Betriebsanleitung

ENGLISH
3-1. Pneumatic tool oil
4-1. Adjuster
5-1. Change lever
5-2. Plastic collated coil
5-3. Wire collated coil
6-1. Door
6-2. Magazine cap
6-3. Lever
7-1. Graduation
7-2. Coil support plate
8-1. Slot

SPECIFICATIONS

Applicable length
Min. hose diameter
Pneumatic tool oil
Dimensions (L X H X W)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear safety glasses.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2 "x 4" housing.
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 86 dB (A)
sound power level: 99 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration
2
value is 6 m/s .
These values have been obtained according to EN792.
EC-DECLARATION OF CONFORMITY
Model; AN621
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
Explanation of general view
8-2. Magnet
8-3. Feeder body
9-1. Air socket
9-2. Air fitting
10-1. Trigger
10-2. Contact element
12-1. Continuous nailing
12-2. Change lever
12-3. Trigger lock
13-1. Exhaust cover
14-1. Small rod
Model
Air pressure
Wire welded nails
Plastic sheet collated nails
Nail capacity
Net weight
END105-1
EN792 in accordance with Council Directives, 98/37/EC.
000230
Responsible Manufacturer:
Makita Corporation
ENE059-1
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
ENG046-1
8JD, ENGLAND
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: WHEN USING THIS TOOL, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED TO REDUCE THE RISK OF PERSONAL
INJURY, INCLUDING THE FOLLOWING:
ENH013-7
READ ALL INSTRUCTIONS.
For personal safety and proper operation and
•
maintenance of the tool, read this instruction
manual before using the tool.
4
14-2. Ejection port
15-1. Hook
18-1. Change lever
18-2. Trigger lock
19-1. Cap
22-1. Magnet
23-1. Drain cock
24-1. Air filter
25-1. Oiler
25-2. Pneumatic oil
AN621
0.44 - 0.83 Mpa (4.4 - 8.3 bar)
45 mm - 65 mm
50 mm - 65 mm
200 - 300 pcs.
6.5 mm
Turbine oil
310 mm X 305 mm X 133 mm
2.8 kg
CE2008
Tomoyasu Kato
Director
ENB067-2