Specifications; Important Safety Instructions - Makita AN450H Betriebsanleitung

ENGLISH
1. Safety glasses
2. Face shield
3. Compressor air output per minute
4. Nailing frequency
5. Pneumatic oil
6. Adjuster
7. Hook
8. Contact element
9. Shingle guide
10. Shingle

SPECIFICATIONS

Min. hose diameter
Pneumatic tool oil
Dimensions (L X H X W)
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
............. Wear safety glasses.
............. Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2" x 4" housing.
IMPORTANT SAFETY
INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS WARNING:
WHEN USING THIS TOOL, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO
REDUCE THE RISK OF PERSONAL INJURY,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
• For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
6
Explanation of general view
11. Projection
12. Lever
13. Adjust plate
14. Magazine cap
15. Latch lever
16. Coil support plate
17. Graduation
18. Arrow
19. Feed Claw
20. Air fitting
Model
Air pressure
Nail length
Nail capacity
Net weight
• Always wear safety glasses to protect your eyes from
END106-2
dust or nail injury.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
• For Australia and New Zealand only Always wear
safety glasses and face shield to protect your eyes
from dust or nail injury. The safety glasses and the face
shield should conform with the requirements of
AS/NZS 1336.
WARNING:
It is an employer's responsibility to enforce the use of
ENE059-1
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
(Fig. 1)
• Wear hearing protection to protect your ears against
exhaust noise and head protection. Also wear light but
not loose clothing. Sleeves should be buttoned or
rolled up. No necktie should be worn.
ENB109-2
• Rushing the job or forcing the tool is dangerous.
Handle the tool carefully. Do not operate when under
the influence of alcohol, drugs or the like.
• General Tool Handling Guidelines:
(1)
(2)
(3)
(4)
(5)
(6)
21. Air socket
22. Trigger
23. Workpiece
24. Change lever
25. Small rod
26. Ejection port
27. Cap
28. Drain cock
29. Air filter
30. Oiler
AN450H
1.28 - 2.26 Mpa (12.8 - 22.6 bar)
19 mm - 45 mm
120 pcs.
5.0 mm
Turbine oil
287 mm X 276 mm X 117 mm
2.2 kg
Always assume that the tool contains fasteners.
Do not point the tool toward yourself or anyone
whether it contains fasteners or not.
Do not activate the tool unless the tool is placed
firmly against the workpiece.
Respect the tool as a working implement.
No horseplay.
Do not hold or carry the tool with a finger on the
trigger.