Specifications; Important Safety Instructions - Makita AN911H Betriebsanleitung

ENGLISH
1 Compressor air output per
minute
2 Nailing frequency (times/min.)
3 Adjuster
4 Too deep
5 Flush
6 Too shallow
7 Hook
8 Screw
9 Protrusion
10 Hole
11 Nose adapter

SPECIFICATIONS

Model
Air pressure
Nail length
Nail capacity
Min. hose diameter
Dimensions (L x W x H)
Net weight
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2" x 4" housing.

IMPORTANT SAFETY INSTRUCTIONS

WARNING:
WHEN USING THIS
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED
TO REDUCE THE RISK OF PERSONAL INJURY,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
• For personal safety and proper operation and mainte-
nance of the tool, read this instruction manual before
using the tool.
• Always wear safety glasses to protect your eyes from
dust or nail injury.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
• For Australia and New Zealand only
Always wear safety glasses and face shield to protect
your eyes from dust or nail injury. The safety glasses
and the face shield should conform with the require-
ments of AS/NZS 1336.
6
Explanation of general view
12 Latch lever
13 Door
14 Adjustfit
15 Change plate
16 Arrow
17 Feed craw
18 Driver channel
19 Contact element
20 Workpiece
21 Trigger
22 Change lever
23 Thickness of workpiece
ENB109-2
TOOL, BASIC SAFETY
1.28 – 2.26 MPa (12,8 – 22,6 bar)
Wire-collated coil nail 45 mm – 90 mm
Sheet-collated coil nail 45 mm – 65 mm
Wire-collated coil nail 150 pcs, 200 pcs, 250 pcs, 300 pcs,
Sheet-collated coil nail 200 pcs
293 mm x 125 mm x 319 mm
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
Safety glasses
Face shield
• Wear hearing protection to protect your ears against
exhaust noise and head protection. Also wear light but
not loose clothing. Sleeves should be buttoned or
rolled up. No necktie should be worn.
• Rushing the job or forcing the tool is dangerous. Han-
dle the tool carefully. Do not operate when under the
influence of alcohol, drugs or the like.
• General Tool Handling Guidelines:
1. Always assume that the tool contains fasteners.
2. Do not point the tool toward yourself or anyone
whether it contains fasteners or not.
3. Do not activate the tool unless the tool is placed
firmly against the workpiece.
4. Respect the tool as a working implement.
5. No horseplay.
24 10 mm or more
25 C-shaped steel
(Thickness 1.6 mm – 3.2 mm)
26 Nail length
27 Wood thickness
28 Concrete range 10 – 15 mm
29 Cap
30 Drain cock
31 Air filter
32 Oiler
33 Pneumatic oil
AN911H
5.0 mm
2.3 kg