Specifications; Important Safety Instructions - Makita AT450H Betriebsanleitung

ENGLISH
1. Safety glasses
2. Face shield
3. Contact element
4. Trigger
5. Workpiece
6. Compressor air output per minute
7. Nailing frequency
8. Adjuster
9. Deep
10. Shallow
11. Too deep

SPECIFICATIONS

Applicable staples
Staple capacity
Min. hose diameter
Dimensions (L X H X W)
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
............. Wear safety glasses.
............. Do not use on scaffoldings, ladders.
Intended use
The tool is intended for pressing staples into construction
materials such as timbers.
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: WHEN USING THIS TOOL, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO
REDUCE THE RISK OF PERSONAL INJURY,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
• For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
• Always wear safety glasses to protect your eyes from
dust or staple injury.
WARNING:
6
Explanation of general view
12. Flush
13. Too shallow
14. Screw
15. Hook
16. Groove
17. Protrusion
18. Flat nose adapter
19. Staple stopper
20. Pusher base
21. Pusher
22. Change lever
Model
Air pressure
Net weight
It is an employer's responsibility to enforce the use of
END106-2
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
• For Australia and New Zealand only
Always wear safety glasses and face shield to protect
your eyes from dust or staple injury. The safety glasses
and the face shield should conform with the
requirements of AS/NZS 1336.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
(Fig. 1)
ENE054-1
• Wear hearing protection to protect your ears against
exhaust noise and head protection. Also wear light but
not loose clothing. Sleeves should be buttoned or
rolled up. No necktie should be worn.
• Rushing the job or forcing the tool is dangerous.
Handle the tool carefully. Do not operate when under
ENB112-1
the influence of alcohol, drugs or the like.
• General Tool Handling Guidelines:
(1)
(2)
(3)
(4)
(5)
(6)
(7)
23. Exhaust cover
24. Exhaust vent
25. Hex wrench
26. Front guide
27. Contact top
28. Drain cock
29. Air filter
30. Oiler
31. Pneumatic oil
32. Thinner
33. Stove
AT450H
1.28 - 2.26 MPa (12.8 - 22.6 bar)
25 mm - 50 mm
84 pcs. (1 strip), max. 105 pcs.
5.0 mm
261 mm X 115 mm X 269 mm
1.4 kg
Always assume that the tool contains fasteners.
Do not point the tool toward yourself or anyone
whether it contains fasteners or not.
Do not activate the tool unless the tool is placed
firmly against the workpiece.
Respect the tool as a working implement.
No horseplay.
Do not hold or carry the tool with a finger on the
trigger.
Do not load the tool with fasteners when any one
of the operating controls is activated.