Specifications; Important Safety Instructions - Makita AN510H Betriebsanleitung

ENGLISH
1 Compressor air output per
minute
2 Nailing frequency (times/min.)
3 Adjuster
4 Shallow
5 Deep
6 Too deep
7 Flush
8 Too shallow
9 Screw

SPECIFICATIONS

Model
Air pressure
Nail length
Nail capacity
Min. hose diameter
Dimensions (L x H x W)
Net weight
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2" x 4" housing.

IMPORTANT SAFETY INSTRUCTIONS

WARNING:
WHEN USING THIS
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED
TO REDUCE THE RISK OF PERSONAL INJURY,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
• For personal safety and proper operation and mainte-
nance of the tool, read this instruction manual before
using the tool.
• Always wear safety glasses to protect your eyes from
dust or nail injury.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
• For Australia and New Zealand only
Always wear safety glasses and face shield to protect
your eyes from dust or nail injury. The safety glasses
and the face shield should conform with the require-
ments of AS/NZS 1336.
Explanation of general view
10 Hook
11 Protrusion
12 Nose adapter
13 Contact element
14 Lever
15 Door
16 Adjustfit
17 Change plate
18 Arrow
19 Nail guide
ENB109-2
TOOL, BASIC SAFETY
20 Feeder
21 Trigger
22 Workpiece
23 Change lever
24 Cap
25 Drain cock
26 Air filter
27 Oiler
28 Pneumatic oil
AN510H
0.98 – 2.26 MPa (9.8 – 22.6 bar)
Wire-collated coil nail 27 mm – 50 mm
Sheet-collated coil nail 25 mm – 50 mm
Wire-collated coil nail 200 pcs, 400 pcs
Sheet-collated coil nail 200 pcs
5.0 mm
260 mm x 255 mm x 111 mm
1.3 kg
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
Safety glasses
Face shield
• Wear hearing protection to protect your ears against
exhaust noise and head protection. Also wear light but
not loose clothing. Sleeves should be buttoned or rolled
up. No necktie should be worn.
• Rushing the job or forcing the tool is dangerous. Han-
dle the tool carefully. Do not operate when under the
influence of alcohol, drugs or the like.
• General Tool Handling Guidelines:
1. Always assume that the tool contains fasteners.
2. Do not point the tool toward yourself or anyone
whether it contains fasteners or not.
3. Do not activate the tool unless the tool is placed
firmly against the workpiece.
4. Respect the tool as a working implement.
5. No horseplay.
6. Do not hold or carry the tool with a finger on the
trigger.
5