Specifications - Makita AN901 Betriebsanleitung

ENGLISH (Original instructions)
3-1. Pneumatic tool oil
4-1. Nose piece storing portion
5-1. Contact arm
5-2. Nose adapter
6-1. Adjuster
7-1. Latch lever
7-2. Door
7-3. Magazine cap
8-1. Magazine scale

SPECIFICATIONS

Dimensions (L X H X W)
Min. hose diameter
Pneumatic tool oil
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear safety glasses.
･
Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2 "x 4" housing.
Noise
The typical A-weighted noise level determined according
to EN792:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
8-2. Coil support plate
9-1. Slot
9-2. Feeder body
10-1. Air fitting
10-2. Air socket
13-1. Continuous nailing
13-2. Intermittent nailing
13-3. Change lever
13-4. Trigger lock
Model
Air pressure
Nail length
Nail capacity
Net weight
) : 87 dB(A)
pA
) : 100 dB(A)
WA
END106-3
Vibration
The vibration emission value determined according to
EN792:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENE059-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
ENG905-1
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
14-1. Small rod
14-2. Ejection port
15-1. Hook
19-1. Change lever
19-2. Trigger lock
22-1. Drain cock
23-1. Air filter
24-1. Oiler
24-2. Pneumatic oil
AN901
0.44 - 0.83 Mpa ( 4.4 - 8.3 bar)
45 mm - 90 mm
150 - 300 pcs.
408 mm X 316 mm X 131 mm
8.5 mm
Turbine oil
3.2 Kg
) : 4.5 m/s
h
2
ENG904-1
2
ENG901-1