Function Of The Keys - Renkforce AN-8006 Bedienungsanleitung

Function of the keys

• Buttons / * (8) and
With these buttons the receiving frequency can be changed to adjust stations in radio operation.
By pressing a button briefly, you activate the auto-scan. The auto-scan only stops at the next station that can be
received well.
To deactivate auto-scan and set the receiver frequency manually, keep the desired button depressed until MANUAL
is displayed (5).

After some time, the device returns to automatic search and the display (5) shows AUTO briefly.
• Button 0 / AMS (10)
If you press this button shortly, the stations stored on the station memory buttons 1-6 (15) are played for 5 seconds
each. To stop the auto-scan, press the button again.
When you keep the button pressed, all the stations that can be received well are stored on the station memory buttons
1-6 (15).
After this procedure, the stored stations are played for approx. 5 seconds each, as described above.
• Button / BAND (11)
With this button you can select the band range of the radio unit. There are 3 FM ranges and 2 MW ranges available:
FM1 > FM2 > FM3 > MW1 > MW2

On each of the 5 band ranges, 6 stations can be stored on the station button 1-6 (15).
• Station buttons 1-6 (15)
Brief press > direct selection of a previously saved station.
Long press > the currently received station is saved on the respective station button.

Each of the three FM bandwidths (FM1-3) and also the two MW bandwidths (MW1-2) has six station
buttons. Therefore you can assign 30 station buttons.
/ # (9)
69