Continuity Test ( ) - VOLTCRAFT VC191 Bedienungsanleitung

e) Continuity test ( )
Make sure all circuit parts, circuits, components, and other objects of measurement
are disconnected from the voltage supply and fully discharged.
1. Set the function dial to
2. Short press the SEL/PEAK button 1x to select
continuity test, "
3. Connect the test leads to the terminals:
- Red test lead to the
- Black test lead to the COM terminal.
4. Connect the test lead probes to the correct test
points in the circuit.
5. A resistance of ≤ 10 Ω is considered continuity,
and a beep will sound.
- The measuring range is ≤ 600 Ω.
- "OL" will appear on the display if the maximum
range is exceeded or if the circuit is open.
6. When finished measuring, disconnect the test
leads and switch the power OFF.
.
" will show on the display.
terminal.
53