Continuity Test ( ) - VOLTCRAFT VC171 Bedienungsanleitung

d) Continuity test ( )
Make sure all circuit parts, circuits, components, and other objects of measurement
are disconnected from the voltage supply and fully discharged.
1. Set the function dial to
2. " " will show on the display.
3. Connect the test leads to the terminals:
- Red test lead to the
- Black test lead to the COM terminal.
4. Connect the test lead probes to the correct test
points in the circuit.
5. A resistance of ≤ 10 Ω is considered continuity,
and a beep will sound.
- The measuring range is ≤ 600 Ω.
- "OL" will appear on the display if the maximum
range is exceeded or if the circuit is open.
6. When finished measuring, disconnect the test
leads and switch the power OFF.
.
terminal.
47