Filter Pump; Min. Hourly Filtering Time; Eco Mode; Enable Filter Pump - Speck-Pumpen Poolregelung BADU Logic 3 Montageanweisung Und Bedienanleitung

5.3. Filter pump

Filter pump run time
The BADU
and the filtering time of the pump, however in eco mode the filtering times for the
minimum hourly and daily filtering run time during solar operation are taken into
consideration.
5.3.1. Min. hourly filtering time
This menu is used to set the hourly filtering time.
This function can be selected in order to avoid a change in temperature and
therefore an unwarranted change in the temperature sensors due to still stand-
ing swimming pool water. Eco mode: If the solar pump or auxiliary heating was
not active during the particular hour, the pump is switched on at the end of the
hour for the set time.
Setting range: off, 1 min. - 60 min. / Default: off

5.3.2. Eco mode

When the eco mode is active the run time for solar and auxiliary heating op-
erations, clear rinse time (for Easytronic) and the minimum hourly run time are
subtracted from the daily filtering time set. Solar operation times and rinse times
(for Easytronic) are subtracted from the hourly filtering time or rather the hourly
filtering time is ignored if the minimum hourly run time is reached or exceeded.
If the eco mode is deactivated, the hourly filtering time and solar operating time
are ignored when calculating the min. daily filtering time. The solar operating
hours are also ignored when calculating the hourly filtering time.
Setting range: on, off/Default: off
5.3.3. Enable filter pump
In this menu the setting for enabling the filter pump via the sensor input S4 can
be made. In addition the clear rinse time and the clear rinse level can also be
set for Easytronic.
Setting range: simple, Easytronic/Default: simple

5.3.4. Clear rinse time

The filter pump will run for the time set here after each release to rinse the system.
Setting range: 0 - 30 Min/Default: 5 Min

5.3.5. Clear rinse stage

Filter pump stage during clear rinse time.
Setting range: 1 - 3/Default: 2

5.3.6. Clear rinse level V1

Level for a variable speed pump connection at V1.
Setting range: 1 - 100 %/Default: 50 %
22
® Logic 3 controls the pool temperature depending on the solar energy
Settings