During Charging; When Activated/In Operation - deuter ALPROOF Serie Benutzerhandbuch

What to do in case of an avalanche:
If there is an avalanche, always try to bring yourself to safe-
ty or escape the avalanche. Also remove your skis or snow-
board if possible, since these act like an anchor in an avalan-
che. As soon as the avalanche starts to lose momentum, close
your mouth and keep your arms in front of your face to create
life-saving access to air. Once the avalanche has stopped and
you have successfully freed yourself, do not remove the airbag
and rush to help others. Only remove your backpack if you are
absolutely sure that a second avalanche will not occur.
10
CHARGING &
SYSTEM STATUS
Charging the Supercapacitators
There are two ways to charge the supercapacitators:
(F)
1. Use the USB-C port
(included) together with a standard charger (sold separately),
such as the kind that you use to charge your mobile phone or a
standard powerbank. Depending on the charger or powerbank
model, charging can take anywhere from 20 to 40 minutes.
2. Install two alkaline or lithium AA batteries
tely). The supercapacitators charge automatically once the
batteries are inserted. Depending on the battery model and
temperature, charging can take anywhere from 40 to 80
minutes.
The charging process is indicated by the rapidly blinking LEDs
(4 x per second), while the charge status is indicated by the LED
(10.1).
color
Please note:
• Charge the system before using it the first time via the USB-C
(F)
connection . After a long period of storage without bat-
teries (e.g. seasonal or a new system), it will take longer to
recharge the supercapacitators than when charging after in-
flation. This is because although after inflation there is still
power in the supercapacitators, after an extended period of
storage without batteries the supercapacitators nevertheless
will lose all power.
• Charging with the USB-C cable
over batteries. If the batteries are installed and the cable is
connected, the system will charge via the cable without emp-
tying the batteries.
• It is also possible to charge the system via the USB-C cable
without installing batteries.
• If the system is charging in OFF mode, the LEDs
blink, but the system still remains in OFF mode.
• The system charges automatically. As soon as the airbag is
inflated, the system immediately begins to recharge using the
batteries or USB-C connection.
(E)
• Two AA batteries can fully recharge the supercapa-
citators twice (depending on the quality of the rechargeable
batteries used and the temperature during charging).
Warning:
Do not leave the USB-C cable (4.3) plugged in while using the
E2 system in the field.
Unplug the USB-C cable after the charge cycle is complete.
Alproof-Booklet_Insert-23-RZ.indd 11 Alproof-Booklet_Insert-23-RZ.indd 11
(4.3)
and standard USB-C cable
(E)
(sold separa-
(4.3)
takes precedence
(H)
will
Summary of LED status:

10.1. During charging

The green LED blinks slowly (1 x every 10 seconds)
The E2 system is fully charged and is ready for
operation for at least six hours.
The orange LED blinks quickly
is charging and is ready for operation for less than
six hours.
The red LED blinks quickly
charging and is not ready for operation.
The charge status does not guarantee full activati-
on of the airbag.
The red LED stays on permanently and the orange
LED blinks quickly
E2 system indicates, since the autotest has detec-
ted a malfunction. The system is charging but is
not ready for operation.

10.2 When activated/in operation

The green LED blinks slowly (1 x every 10 seconds)
The E2 system is fully charged and is ready for
operation for at least six hours.
The orange LED blinks slowly
charging and is ready for operation for less than
six hours.
The red LED blinks slowly
ready for operation. The charge status does not
guarantee full activation of the airbag.
The red LED stays on continuously
a defect in the E2 system, since the autotest has
detected a malfunction. The system is not ready
for operation.
E2 system runtime
System runtime depends on the quality of the AA batteries the
power that they deliver, and the frequency and duration of
use in ON or OFF mode. The following times are based on the
use of high-quality alkaline batteries.
• Approx. 2 to 3 months with two new AA alkaline batteries
without charging the supercapacitators (new batteries instal-
led after charging the supercapacitators).
• The system can also run without additional AA batteries.
However, we recommend always using the system with the
batteries to extend the runtime.
• If the system is operated without batteries and the LEDs blink
green, then runtime is at least six hours.
Note:
If the system is charged with a USB-C cable (4.3) and
operated without batteries, then it can run a maximum 12 to
24 hours in autonomous mode. This is perfectly
normal, because AA batteries guarantee autonomous
operation of the ALPRRIDE E2 system.
EN
The E2 system
The E2 system is
There is a defect in the
The E2 system is
The E2 system is not
There is
29.03.22 19:33 29.03.22 19:33