Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Beam angle
As optional accessories, you can purchase two diffuser discs with which you can change the beam angle
from 16° to approx. 15x60° or 40°. The diffuser discs can be magnetically attached on the device.
DMX512 CONTROL
DMX Controller
DMX Controller
Via DMX cable
A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin XLR
connectors for DMX connection.
1
Connect the output of your DMX controller to the DMX input DMX IN of the device with a DMX cable.
2
Connect the DMX output DMX OUT of the device to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3
At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4
If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
XLR connection:
Device 1
Start Address 1
POWER IN
POWER IN
ON/OFF
ON/OFF
DMX IN
DMX IN
DMX OUT
DMX OUT
Program
Program
Chase32 Step100
Chase32 Step100
Device 2
Start Address 10
POWER IN
POWER IN
ON/OFF
ON/OFF
DMX IN
DMX IN
DMX OUT
DMX OUT
25/36
Device 3
Start Address 19
POWER IN
POWER IN
ON/OFF
ON/OFF
DMX IN
DMX IN
DMX OUT
DMX OUT
00133497, Version 1.1
Werbung
Inhaltsverzeichnis
