Installation; Changing The Beam Angle - EuroLite MULTIFLOOD PRO IP RGBW Wash & Frost Bedienungsanleitung

INSTALLATION

WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device may be fastened to a truss or similar rigging structure. The device must never be fixed swinging
freely in the room.
1 The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2 Block access below the work area and work from a stable platform when installing the device.
3 Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware.
4 Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. An
appropriate hole is installed on the mounting bracket for fixation of the safety rope. Fasten the safety
rope in such a way that, in the event of a fall, the maximum drop distance of the device will not exceed
20 cm.
5 To align the device, release the fixation screws at the mounting bracket, adjust the desired inclination
angle and retighten the fixation screws.
6 After installation, the device requires inspections periodically to prevent the possibility of rot, deformation
and looseness.
Screw one clamp via an M10 screw and self-locking nut onto the Omega holder.
Insert the quick-lock fasteners of the Omega holder into the respective holes on the mounting plate. Tighten
the quick-lock fasteners fully clockwise.
(1) Clamp
(2) Quick-lock fastener
(3) Omega holder

Changing the beam angle

For a softer light with larger beam angles, please use the enclosed frost filters.
With the delivery of the device you receive two frost filters, with which the beam angle can be changed from
the standard 16° (without filter) to approx. 25 ° or approx. 45 °. If you want to change the beam angle of the
device, attach the desired frost filter to the front of the device using the four knurled screws. Make sure the
screws are tightened to prevent accidental release of the frost filter.
Before fastening/removing the frost filters unplug mains lead.
1
2
3
20/28 00122161.DOCX, Version 1.0