Remote Control Ir-7 - EuroLite AKKU IP UP-4 Entry QCL Spot QuickDMX Montageanleitung

Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAVE is indicated on the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.
Master/slave operation via QuickDMX
1 Set the master device and each slave device to the same transmission channel using the function SET
2.4G. Thus, the spotlights are paired.
2 Set the master unit to the desired operating mode and all slave units to SLAVE mode. The devices will
now operate in sync.
Energy-saving mode
The ECO mode offers the possibility to adjust the battery life.
1 Press the MENU button so many times until ECO is indicated in the display. Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to choose energy saving mode ON or OFF. Confirm with the ENTER
button.
Key lock
Enable or disenable the lock passcode on the display screen.
With PASSCODE function you can lock the keys of the Control Board to e.g. prevent menu tampering. If this
function is activated, the keys will be automatically locked from the last command. In order to deactivate the
keylock function, press these keys in the following order: UP, DOWN, UP, DOWN, ENTER.
QuickDMX transmission channel
You can use the SET 2.4G menu to set the wireless transmission channel for QuickDMX operation. Please
refer to the corresponding chapters for further explanation.

Remote control IR-7

The device must be activated for remote control. For this, set menu item INFRARED to ON. When actuating
a button, always direct the remote control towards the sensor. There must be no obstacles between remote
control and the sensor.
Button Function
BLACKOUT LEDs off
AUTO
Automatic mode; program selection with (+)/(‒)
STROBE Strobe effect for automatic mode;
flash rate setting with (+)/(‒)
Running speed in
SPEED
setting with (+)/(‒)
DMX DMX mode
MANUAL
Color mode; select colors with R/G/B/W
setting with (+)/(‒)
FADE Color fade mode, press the FADE key again to turn
off the FADE function, use (+)/(‒) to set the FADE
program speed
1-9
Total brightness; 1 = dark, 9 = bright
30/36
automatic mode;
00133497, Version 1.1