Replacement Of Batteries - Aiwa ACD-24KBTU Gebrauchsanweisung, Installationsanleitung

21) Child-Lock
22) Display ON/OFF
23) To turn on/off the air conditioner.
24) To increase temperature, or Timer setting hours.
25) To decrease temperature, or Timer setting hours.
26) MODE To select the mode of operation (AUTO,
COOL, DRY, FAN, HEAT).
27) ECO To activate/deactivate the ECO function.
Long press to activate/deactivate the 8ºC heating
function (depending on models).
28) TURBO To activate/deactivate the TURBO function.
29) FAN To select the fan speed of auto/low/mid/high.
30) TIMER To set the time for timer on/off.
31) SLEEP To switch-on/off the function SLEEP.
32) DISPLAY To switch-on/off the LED display.
33) SWING To stop or start horizontal flaps louver

REPLACEMENT OF BATTERIES

Remove the battery cover plate from the rear of the
remote control, by sliding it in direction as the arrow.
Install the batteries according the direction (+ and -)
shown on the Remote Control.
Reinstall the battery cover by sliding it into place.
Use 2 pieces LRO3 AAA (1.5V) batteries.
Do not use rechargeable batteries.
Replace the old batteries with new ones of the
same type when the display is no longer legible.
Do not dispose batteries as unsorted municipal
waste. Collection of such waste separately for
special treatment is necessary.
For some model, each time when insert the
batteries in the remote controller for the first
time, you can set the Cooling only or Heating
pump control type. As soon as you insert the
batteries, turn off the remote controller, and
operate as below.
1. Long press the MODE button, until the (
icon flash, to set the Cooling only type.
2. Long press the MODE button, until the (
icon flazsh, to set the Heating pump type.
Note: If you set the remote control in cooling
mode, it will not be possible to activate the
heating function in units with a heating pump.
If you need to reset, take out the batteries and
install again.
For some models of the remote controller, you
can program the temperature display between
ºC and ºF.
1. Press and hold the TURBO ,button over 5
seconds to get into the change mode;
2. Press and hold the TURBO until it switch to
ºC and ºF.;
3. Then release the pressing and wait for 5
seconds, the function will be selected.z
movement or set the desired up/down air flow
direction.
34) SWING To stop or start vertical deflectors louver
movement or set the desired left/right air flow
direction.
35) I FEEL To switch-on/off the I FEEL function.
36) MUTE To switch-on/off the MUTE function. Long
press to activate/deactivate the GEN function
(depending on models).
37) I SET To memory the setting temperature, setting
mode and setting fan speed as you need.
The display and some functions of the remote control
may vary according to the model.
The shape and position of buttons and indicators may
vary according to the model, but their function is the
same.
The unit confirms the correct reception of each button
with the beep.
Note:
1. Direct the remote control toward the Air conditioner
)
2. Check that there are no objects between the remote
control and the Signal receptor in the indoor unit.
)
3. Never leave the remote control exposed to the rays
of the sun.
4.
Keep the remote control at a distance of at least 1m
from the television or other electrical appliances.
EN
ACD-24KBTU 9