Outdoor Unit Installation - Aiwa ACD-24KBTU Gebrauchsanweisung, Installationsanleitung

Take off the bottom plate

OUTDOOR UNIT INSTALLATION

Step 1: Select Installation Location
Select a site that allows for the following:
1)
Do not install the outdoor unit near sources of heat,
steam or flammable gas.
2) Do not install the unit in too windy or dusty places.
3) Do not install the unit where people often pass.
Select a place where the air discharge and
operating sound will not disturb the neighbors.
4) Avoid installing the unit where it will be exposed
to direct sunlight ( other wise use a protection, if
necessary, that should not interfere with the air
flow).
5)
Reserve the spaces as shown in the picture for the
air to circulate freely.
6) Install the outdoor unit in a safe and solid place.
7) If the outdoor unit is subject to vibration, place
rubber blankets onto the feet of the unit.
Step 2: Install Drainage Hose
1)
This step only for heating pump models.
2) Insert the drainage joint to the hole at the bottom
of the outdoor unit.
3) Connect the drainage hose to the joint and make
the connection well enough.
Step 3: Fix Outdoor Unit
1)
According to the outdoor unit installation
dimensions to mark the installation position for
expansion bolts.
2)
Drill holes and clean the concrete dust and place
the bolts .
3) If applicable install 4 rubber blankets on the hole
before place the outdoor unit (Optional). This will
reduce vibrations and noise.
4) Place the outdoor unit base on the bolts and pre-
drilled holes.
5) Use wrench to fix the outdoor unit firmly with bolts.
24 ACD-24KBTU
Unfold the bracket on the mounting plate
Over 30cm/ 12 in.
Step 1
Step 2
Step 3
Over 200cm/ 79 in.
Drainage hose Drainage joint
Install 4 rubber blankets (Optional)
Over 50cm/
20 in.