Aiwa ACD-24KBTU Gebrauchsanweisung, Installationsanleitung Seite 28

• Grasp the raised handle on the filter by hand, and then pull the filter out in the direction
deviating from the unit, so that the upper edge of the filter is separated from the unit. The filter
can be removed by lifting the filter upwards.
• When installing the filter, first insert the lower end of the filter screen into the corresponding
position of the unit, and then squeeze the upper end of the filter into the corresponding
Disassembly
buckling position of the unit body.
and
assembly
of filter
Clean the
filter
Take out the filter
from the unit
Tip: When you find accumulated dust in the filter, please clean the filter in time to ensure the
clean, healthy and efficient operation inside the air conditioner.
• First, loosen the knob on the middle of louver and bend the louver outwards to take it out.
• Then, grasp both sides of bottom plate push downwards to take down the bottom plate.
• Finally, loosen the buckle of deflector assembly with your thumb and take it out.
Cleaning • Wipe the air duct and fan assembly with a clean and wrung wet rag.
of inner
• Clean the removed parts with soapy water and air dry it.
air duct
• After cleaning, restore the removed parts in turn.
Louver
• When the air conditioner is not in use for a long time, do the following work:
Take out the batteries of the remote controller and disconnect the power supply of the air
Service and
conditioner.
maintenance
• When starting to use after long-term shutdown:
1. Clean the unit and filter screen;
2. Check whether there are obstacles at the air inlet and outlet of indoor and outdoor units;
3. Check whether the drain pipe is unobstructed;
Install the batteries of the remote controller and check whether the power is on.
28 ACD-24KBTU
Handle
Clean the filter with
soapy water and air dry it
Deflector assembly
Bottom plate
<40ºC
(104ºF)
Opposite to the
direction of
taking
out the filter
Replace the filter
<40ºC
(104ºF)