Aiwa ACD-24KBTU Gebrauchsanweisung, Installationsanleitung Seite 25

Step 4: Install Wiring
1)
Use a phillips screwdriver to unscrew wiring cover,
grasp and press it down gently to take it down
2) Unscrew the cable clamp and take it down.
3)
According to the wiring diagram pasted inside
the wiring cover, connect the connecting wires
to the corresponding terminals, and ensure all
connections are firmly and securely.
Terminal block
Cable clamp
Wiring cover
Step 5: Connecting Refrigerant Pipe
1) Unscrews the valve cover, grasp and press it
down gently to take it down(if the valve cover is
applicable).
2)
Remove the protective caps from the end of valves.
3) Take off the plastic cover in the pipe ports and
check whether there is any sundry on the port of
the connecting pipe and make ensure the port is
clean.
4) Reinstall the cable clamp and wiring cover.
Note: When connecting the wires of indoor and outdoor
units, the power should be cut off.
Wiring diagram
4) After align the center, rotate the flare nut of the
connecting pipe to tighten the nut as tightly as
possible by hand.
5)
Use a spanner hold the body of the valve and use a
torque wrench to tighten the flare nut according to
the torque values in the torque requirements table.
(Refer to the torque requirements table on section
INSTALLATION PRECAUTIONS)
Take down the valve cover
Outdoor
POWER SUPPLY
Indoor
Wiring diagram
ACD-24KBTU 25
EN