Starting The Pump - Agilent Technologies Turbo-V 2000 ICE Bedienungshandbuch

When PUMP LIFE is reset to 000, the CYCLE number is also reset to 000.
NOTE

Starting the Pump

If the forepump and vent device are not operated by the controller,
close the vent valve and switch on the forepump.
Before starting the pump the cooling mode must be selected.
NOTE
With the FRONT panel operation selected, the REMOTE and RS 232/422/485
NOTE
operations are inoperative; conversely, the CYCLE NUMBER and PUMP
CURRENT push-buttons are always active, even when the operating mode
selected is REMOTE or RS 232/422/485.
S
Figure 33
Turbo-V 2000 ICE Controller User Manual / 87-900-929-01 (L)
O F T S
[ - - -
Technical Information
T A R T
- - - - -
17
Use
O N
- - ]
247/260