Use Procedure; Controller Startup; Starting The Pump; Pump Shutdown - Agilent Technologies Turbo-V 70 PCB Bedienungshandbuch

Use Procedure

Controller Startup

To startup the controller plug the power cable into a suitable power
source.

Starting the Pump

To start the pump send the START command to related pins of the
input connector (pin 1 - 6 of P1 connector), or, when the hand held
terminal is available, press the START pushbutton.

Pump Shutdown

To shutdown the pump remove the START command from the related
pins of the input connector (pin 1 - 6 of P1 connector), or, when the
hand held terminal is available, press the STOP pushbutton.
Turbo-V 70 PCB Controller User Manual / 87-900-871-01 (E)
Instructions for Use

Use Procedure

231/280
16