Transport; Storage; Care And Maintenance; Inspection And Maintenance Work - Kärcher IVM 100/36-3 Oss Bedienungsanleitung

Observe the total weight of the dirt recepta-
cle when transporting it by crane.
Do not overload the receptacle.
Observe the valid instructions for crane op-
eration.
WARNING
Improper handling when locking the dirt
receptacle
Risk of crushing
Under no circumstances should you hold
your hands between the dirt receptacle and
filter ring or allow them to come close to the
lifting mechanism while locking it.
Lock the dirt receptacle by operating the
bow handle with both hands.
8. Insert the dirt receptacle into the device
in reverse order.
Illustration B
9. Press the illuminated pressure switch.
The light goes out.

Transport

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transportation.
1. Secure the device against slipping and
tipping over when transporting in vehi-
cles.

Storage

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
storage.
1. Store the device indoors only.

Care and maintenance

DANGER
Disconnecting the fill level sensor plug
Risk of electric shock
The fill level sensor plug may only be dis-
connected by trained specialist or service
personnel.

Inspection and maintenance work

Have the device regularly inspected ac-
cording to the respective national accident
prevention regulations. Maintenance work
as specified by the manufacturer must be
performed by a technically qualified person
at the specified regular intervals and in ac-
cordance with the applicable regulations
and safety requirements. Work on electrical
components may only be performed by a
qualified electrician. Please contact a
KÄRCHER branch office if you have any
questions.
Maintenance intervals / user
No periodic maintenance intervals are
specified for this device. The following
maintenance is to be performed as neces-
sary:
● Wash the filter.
● Change the filter.
● Replace the filter.
ATTENTION
Use of detergents or bleach
Damage to the filter.
Clean the filter with water only. Only fit the
filter in the device when it is completely dry.
The star folded filter can be washed out un-
der running water.
1. Always flush the star folded filter from
the inside to the outside so that no re-
maining particles impair the filter perfor-
mance.
Changing/replacing the filter
1. Switch off the device.
2. Pull out the mains plug.
ATTENTION
Incorrect removal of the suction head
Damage to the plug of the fill level sensor
Be careful not to damage the fill level sen-
sor connector when removing the suction
head.
Place the suction head near the unit so that
the cable of the level sensor plug is not
stretched.
3. Unlock and remove the suction head.
4. Unlock and remove the spacer.
5. Remove the star pleated filter.
6. Check the sealing ring for damage.
7. Insert the new star pleated filter:
English
maintenance
Wash the filter
15