Changing Air-Oil Separator; Cleaning Radiator - Comprag FV30 Bedienungsanleitung

5.7

Changing air-oil separator

Fig. 5.7 Changing air-oil separator
5.8

Cleaning radiator

Fig. 5.8 Cleaning radiator
COMPRAG Screw air compressor FV-Series
The separating component (1) is
located within the separator tank.
2
Open the front panel in order to
1
change it. Unscrew the bolts (2) and
carefully remove the top cap of the
tank. Disconnect hoses if they make it
difficult to remove the cap. Remove the
spent separator and install a new one
in its place. Refasten the tank cap
In order to access the radiator (1), open
the front or right panel. Regularly clean
the radiator in order to maintain its cool-
ing efficiency at an acceptable level.
1
Remove any dirt particles from the radi-
ator using a fibre brush, then aim a jet
of compressed air at the radiator from
the bottom to the top; the jet should be
held at an approximate 90° angle to the
plane of the radiator.
.
29