Changing Drive Belt; Changing Air-Oil Separator - Comprag A9008 Bedienungsanleitung

5.6

Changing drive belt

4 4
3 3
Fig. 5.6 Changing drive belt
Open the front and left side panel. Remove the protective metal grid. Loosen the 2 screws
(1) and the 2 nuts (1) securing the bracket of the air end by turning them 2 revolutions.
Loosen the 2 bolts (4) of the support and the 2 corresponding nuts (3) on the tensioner
using a wrench. Remove the old belts from the pulleys and install the new belts. After
installing the new belt, tighten the belt with the appropriate tensile force (see section 5.3
Checking Drive Belt). Tighten the 2 bolts (4) of the support and the 2 corresponding nuts on
the tensioner. Tighten the 2 screws and the 2 nuts of the bracket of the air end. Check the
belt tension within four hours of the compressor's operation in accordance with section 5.3.
Move the protective metal grid back.
5.7

Changing air-oil separator

Fig. 5.7 Changing air-oil separator
28
2 2 1 1
The separating component (1) is
2
located within the separator tank.
1
Open the front panel in order to
change it. Unscrew the bolts (2) and
carefully remove the top cap of the
tank. Disconnect hoses if they make it
difficult to remove the cap. Remove the
spent separator and install a new one
in its place. Refasten the tank cap
.
Version 1.0