SATA SATAjet 1000 K Betriebsanleitung Seite 97

Operating instructions SATAjet 1000 K (RP/HVLP), H RP
Should the material connection 93526 in the spray gun body loosen when removing
the material tube 92031 (version Jet 1000 K) or the suction cup 2691 (version Jet 1000
H), respectively, please proceed as follows:
• Remove material connection 93526 completely
• Pull out the insert 93559 from the spray gun via the paint nozzle and remove paint
nozzle
• Plug in insert 93559 aligned with drilling for the material connection
• Seal material connection with Loctite 638 and install, required locking torque
40-45 Nm
A mounting instruction of the air distribution ring can be found as a PDF and as a
video on our homepage www.sata.com/Media. Also more information on spray gun
cleaning can be obtained from a video.
Important Notice:
Gun may be cleaned with solvent or cleaning agents manually or in a conventional gun
washing machine.
The following actions damage the gun/system, may lead to the loss of the
explosion-proofness approval and entirely annull any warranty claims:
- Immersing the gun in solvent or cleaning agents, or for a period longer than required for
the cleaning process as such
- Storing the gun inside the gun washing machine
- Cleaning the gun by means of ultrasound cleaning systems
- Cleaning of the display glass with pointed, sharp-edged or abrasive objects
- Exerting violent, inappropriate treatment
IX.7