SATA SATAjet 1000 K Betriebsanleitung Seite 93

Operating instructions SATAjet 1000 K (RP/HVLP), H RP
4. Putting into Operation
Before putting into operation, and especially after each cleaning and any repair work,
check to see that all screws and nuts are tight. This applies in particular for the material
flow control screw (counter nut), the round/flat spray control (pos. 5) as well as the fixing screw
(pos. 9) for the air micrometer. The paint spray gun has been treated with an anticorrosive agent
before leaving the factory and must therefore be flushed out thoroughly with thinner before use. For
servicing/repair work of any kind, the system must be devoid of pressure, i.e. disconnected from the
air supply. Failure to respect this safety warning may result in damage and injuries, even death at
worst. SATA does not take any responsibility for possible results of such failure.
Material connection with:
SATAjet 1000 K RP/HVLP
a) Connect material hose of pressure pot,
respectively pump to the spray gun.
b) Adjust requested atomisation pressure
with pulled trigger. Then adjust material
feed pressure with pulled trigger. Please
check spray pattern on paper or other
suitable substrate and adjust pressure
accordingly, if necessary.
4.1 Clean Spray air
...best obtained by using a combi fine filter unit with integrated pressure
regulator, for rough spray pressure adjustment. Due to high pressure drop in
the air hose/coupling, the actual dynamic air pressure should be checked and
fine-adjusted at the spray gun air inlet.
part. no. 92296
4.2 Suffi cient air volume
...obtained by an appropriate compressor, large air line diameters and, to
avoid too much pressure drop, an air hose with minimum 9 mm inner diameter
in antistatic and pressure-resistant version and free from substances affecting
the painting result. Blow out the air hose before attaching it to the air connec-
tion (G 1/4 ext.). The air hose must be pressure-resistant for min. 145 psi and
solvent-resistant. Total electric resistance: < 100 million Ohm.
part. no. 53090 (Length 10m) - (non-resistant against petrol and oil)
4.3 Air micrometer/Exchange Manometer
For maximum air flow, fully open integrated Micrometer, i.e. put into vertical
position III. By means of the variable adjustable air micrometer the internal
spray gun presure can be set directly at the gun. Connect the spray gun to
the air supply, pull the trigger and adjust the requested spray gun internal
pressure.
SATAjet 1000 H RP
c) Please mount the suction cup lid fitting in a
way that the lock for the cup lid faces
towards the nozzle (please see spare part
drawing).
IX.3