Properties Of Your Design Kettle Express; Shortcuts - Gastroback Design Wasserkocher Express Bedienungsanleitung

PROPERTIES OF YOUR DESIGN KETTLE EXPRESS

Your new Design Kettle Express is intended for heating up drinking water to a selec-
table temperature in the range between 50°C to boiling temperature (100°C). You
may cancel any running heating cycle at any time you like by pressing the ON/
OFF button or removing the kettle from the power base.
WARNING
check, whether the power outlet you are going to use is rated for at least 16 A to
avoid overloading the power supply.
NOTE
There is no way to change the set temperature while a heating cycle is running
(ON/OFF button is illuminated). If you wish to set another temperature, you must
cancel any running heating cycle first (ON/OFF button gets dark). Thereafter, with
the appliance in standby mode, you may set a new temperature value.
IMPORTANT - Always close the lid for operation. With the lid open, the tempe-
rature control and automatic shut-off will not work properly and there will be high
energy loss.
IMPORTANT - Depending on the water hardness of your drinking water, the appli-
ance needs regular de-scaling (see: 'Care and Cleaning'). Otherwise, the tempe-
rature control will not work properly, there will be an increasing energy loss, and
overheating of the heating elements could occur.

SHORTCUTS

The temperature settings 100°C (boiling), 80°C, and 60°C are available via short-
cuts.
NOTE
The shortcuts are available in standby mode only. Additionally, you must start
the heating process via the ON/OFF button within 6 seconds. Otherwise the
appliance will switch back to standby mode.
The following shortcuts are accessible.
– Before connecting the appliance to the power outlet, always
EN
39