Properties Of Your Design Water Kettle Camping; Shortcuts - Gastroback 42445 Bedienungsanleitung

PROPERTIES OF YOUR DESIGN WATER KETTLE CAMPING

Your new Design Water Kettle Camping is intended for heating up drinking water
to a selectable temperature in the range between 50°C to boiling temperature
(100°C). You may cancel any running heating cycle at any time you like by pressing
the ON/OFF button or removing the kettle from the power base.
NOTE
There is no way to change the set temperature while a heating cycle is running
(ON/OFF button is illuminated). If you wish to set another temperature, you must
cancel any running heating cycle first (ON/OFF button gets dark). Thereafter, with
the appliance in standby mode, you may set a new temperature value.
IMPORTANT - Always close the lid for operation. With the lid open, the tempe-
rature control and automatic shut-off will not work properly and there will be high
energy loss.
IMPORTANT - Depending on the water hardness of your drinking water, the appli-
ance needs regular de-scaling (see: 'Care and Cleaning'). Otherwise, the tempe-
rature control will not work properly, there will be an increasing energy loss, and
overheating of the heating elements could occur.

SHORTCUTS

The temperature settings 100°C (boiling), 80°C, and 60°C are available via short-
cuts.
NOTE
The shortcuts are available in standby mode only. Additionally, you must start
the heating process via the ON/OFF button within 6 seconds. Otherwise the
appliance will switch back to standby mode.
The following shortcuts are accessible.
Temperature
100°C
80°C
60°C
EN
36
Hold the KEEP WARM button pressed for 2 seconds until 100 is shown on
the display.
Hold the temperature selection button and KEEP WARM button pressed
simultaneously for 2 seconds until 80 is shown on the display.
Hold the temperature selection button pressed for 2 seconds until 60 is
shown on the display.
Shortcut