Important Safeguards For Electrical Appliances - Gastroback Design Wasserkocher Express Bedienungsanleitung

• If liquids run out or are spilled onto the exterior of the power base
or kettle, immediately unplug the appliance. Always wipe off spilled
liquids immediately. If in doubt, check the kettle for leakage, before
operating the appliance again.
• Do not place any hard and/or heavy objects on or in the appliance
or any part of it.
• Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring
pads), or any corrosive chemicals (e.g. bleach) for cleaning. Do not
place the appliance or any part of it in an automatic dishwasher!
• Depending on the hardness of your water, you need to de-scale the
kettle regularly. A large amount of scale will lead to energy loss and
could cause damage to the appliance (see: 'Care and Cleaning').

IMPORTANT SAFEGUARDS FOR ELECTRICAL APPLIANCES

The appliance is heated electrically via extremely high-powered hea-
ting elements. Place the appliance near a suitable wall power outlet to
connect the appliance directly to a separately connected and protected
mains power supply with protective conductor (earth/ground) connected
properly. Ensure that the ratings of your mains power supply correspond
to the requirements of the appliance (220/240 V AC, 50/60 Hz, at
least 16 A). Do not operate any other appliances via the same power
outlet simultaneously to avoid overloading your power supply.
• Always switch off the kettle via the ON/OFF button, before removing
the kettle from the base or unplugging the appliance to avoid extreme
load to the electrical connectors of the kettle and base, or power plug
and power outlet.
• The installation of a residual current operated circuit breaker (r.c.c.b.)
with a maximum rated residual operating current of 30 mA in the sup-
plying electrical circuit is strongly recommended. If in doubt, contact
your electrician for further information.
• In various foreign countries, the specifications for power supplies are
subject to incompatible norms. Therefore it is possible that power sup-
plies in foreign countries do not meet the requirements for safe opera-
EN
34