Solving Problems - Gastroback Design Wasserkocher Express Bedienungsanleitung

SOLVING PROBLEMS

If any problems occur during operation, you will find the solution in the following
table.
Problem
Emergency stop required?
The display remains
dark. No signal sounds,
when placing the kettle
on the power base.
EN
46
Possible Reason
The appliance is not live. Ensure that the appliance is connected to a suitable
The overheat protection
system has been trig-
gered.
A severe problem occur-
red.
The used power outlet is
not rated sufficiently. The
power supply fuses, when
switching on the kettle.
The Easy Solution
As an exception, immediately unplug the appliance.
wall power outlet. Ensure that the wall power outlet is
live by connecting a lamp. When it is not live, refer to
the following entry, too.
Do not attempt to operate the appliance
with the electrical connectors damaged in
any way and/or when your power supply
fuses repeatedly!
Check, if the kettle is connected correctly to the power
base. Turn it a little.
Empty the kettle and leave the kettle cool down for at
least 30 minutes. If required, de-scale the kettle. Then
try again.
Take the kettle off the power base and unplug the
power base. Get in contact with an authorised service
centre for examination and repair.
Unplug the appliance. Before operation, always ensure
that the power outlet is rated for 16 A at least!
Do not attempt to operate any other appli-
ances via this power outlet simultaneously.
Do not attempt to operate the appliance,
when your power supply fuses repeatedly! If
in doubt, contact your electrician.