Memory Function; Display And Sounds; Self-Resetting Dry Boil Protection - Gastroback Design Wasserkocher Express Bedienungsanleitung

MEMORY FUNCTION

The appliance will keep the recently set temperature in memory, even after switching
off and disconnecting the appliance from the power supply.
IMPORTANT - To save any set temperature in memory, you need to start a heating
cycle. Thereafter, you may cancel the heating cycle immediately. Nevertheless,,
the set temperature will be kept in memory.

DISPLAY AND SOUNDS

When connecting the appliance to the power supply, a signal sounds and the actu-
al water temperature in the kettle will be shown on the display. However, with the
water temperature below 30°C, two dashes will be shown. After pressing the ON/
OFF button, the appliance will start heating immediately up to the set temperature.
During a heating cycle, the ON/OFF button is illuminated in red. As soon as the set
temperature is reached, several beeps sound and, with the keep warm function acti-
vated, the ON/OFF button changes to yellow indicating the keep warm function.
After another 30 minutes the ON/OFF button will get dark indicating the standby
mode. An additional acoustic signal sounds. However, the actual water temperature
will still be shown on the display.
When pressing the temperature selection button shortly with a heating cycle run-
ning the set temperature will flash on the display. If you do not press any button for
approx. 6 seconds, the actual water temperature in the kettle will be shown again.
NOTE
If the appliance is idle for approx. 30 minutes, the display is switched off
completely and gets dark. To reactivate the display again, simply press any button.

SELF-RESETTING DRY BOIL PROTECTION

The water kettle is fitted with a self-resetting dry boil protection device, which safegu-
ards against overheating of the heating elements. Overheating may be caused by ...
• too much scale on the heating elements. De-scale the kettle in time (see: 'Care
and Cleaning').
• too little water in the kettle. Always observe the MIN filling level (0.5 litre).
If overheating occurs, all button lights get dark simultaneously and the kettle will
automatically switch off the heating elements with an acoustic signal. Thereafter, the
kettle will switch off completely. In this case, remove the kettle from the power base
and pour out the water. Then leave the kettle cool down by waiting approx. 30
minutes. Thereafter, you can reactivate the appliance. If required, de-scale the kettle.
EN
41