Transport; Care And Maintenance - Kärcher KM 120/250 R D Bedienungsanleitung

 Pull the motor speed adjustment all the
way to the back.
 Press brake pedal and keep it de-
pressed.
 Lock parking brake.
 Turn ignition key to "0" and remove it.

Transport

DANGER
Transport damage!
 Observe the net weight (transport
weight) of the device during transport
on trailers or vehicles.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
 Turn ignition key to "0" and remove it.
 Lock parking brake.
 Secure the appliance at the lashing
points (4x) using tension belts, ropes or
chains.
 Secure the wheels of the machine with
wheel chocks.
 Disconnect the battery of the sweeper
during transport.
Storage/decommissioning
DANGER
Risk of injury and damage! Note the weight
of the appliance in case of storage.
 Park the sweeper on a level surface in
a dry, frost protected area. Protect it
against dust by means of covering ma-
terial.
 Raise the roller brush and the side-
brushes to prevent the bristles from be-
ing damaged.
 Close the container flap.
 Turn ignition key to "0" and remove it.
 Lock parking brake.
 Lock the sweeper to ensure that it does
not roll off.
Additionally observe the following points if
the sweeper is not used over a longer peri-
od of time:
 Change engine oil.
 Drain off the cooling water if frost is ex-
pected and check whether there is ade-
quate anti-frosting agent.
 Clean the inside and outside of the
sweeper.
 Disconnect battery.
 Charge battery and recharge it approx.
every 2 months.

Care and maintenance

General notes
ATTENTION
Risk of damage!
 Do not rinse out the dust filter.
 Maintenance work may only be carried
out by approved customer service out-
lets or experts in this field who are famil-
iar with the respective safety regula-
tions.
 Mobile appliances used for commercial
purposes are subject to safety inspec-
tions according to VDE 0701.
 Park the sweeper on an even surface.
24
 Turn ignition key to "0" and remove it.
 Lock parking brake.
Cleaning
CAUTION
Risk of damage!
 Do not clean the appliance with a water
hose or high-pressure water jet (danger
of short circuits or other damage).
Cleaning the inside of the machine
DANGER
Risk of injury!
 Wear dust mask and protective gog-
gles.
 Clean machine with a cloth.
 Blow through machine with com-
pressed air.
External cleaning of the appliance
 Clean the machine with a damp cloth
which has been soaked in mild deter-
gent.
Note: Do not use aggressive cleaning
agents.
Maintenance intervals
Note: The elapsed-time counter shows the
timing of the maintenance intervals.
Maintenance by the customer
Note: Where maintenance is carried out by
the customer, all service and maintenance
work must be undertaken by a qualified
specialist. If required, a specialised Kärch-
er dealer may be contacted at any time.
Daily maintenance:
 Check fill level of fuel tank.
 Check engine oil level.
 Check the filling level in the coolant ex-
pansion tank.
 Check the sweeping roller and the side
brush for wear and wrapped belts.
 Check fuel filter.
 Check the centrifugal separator and the
air filter, clean if required.
 Check function of all operator control el-
ements.
 Check appliance for damages.
Weekly maintenance:
 Clean the water cooler.
 Clean the hydraulic oil cooler.
 Check hydraulic unit.
 Check the hydraulic oil level.
 Check brake fluid status.
 Check the pad for wear, replace if re-
quired.
 Check the container lid and lubricate it.
Maintenance to be carried out every 50
operating hours:
 Drain the water from the diesel/water
separator.
Maintenance following wear:
 Replace sealing strips.
 Readjust the side seals or replace
them.
 Replace roller brush.
 Replace side brush.
Note: For description, see section on Main-
tenance work.
7
-
EN
Maintenance by Customer Service
Note: In order to safeguard warranty
claims, all service and maintenance work
during the warranty period must be carried
out by the authorised Kärcher Customer
Service in accordance with the mainte-
nance booklet.
Maintenance to be carried out after 50
operating hours:
 Have the first maintenance performed
by the customer service in accordance
with the inspection check list.
Maintenance after 250/500/1000/1500/
2000 operating hours:
 Have the maintenance performed by
the customer service in accordance
with the inspection check list.
Maintenance Works
Preparation:
 Park the sweeper on an even surface.
 Turn ignition key to "0" and remove it.
 Lock parking brake.
General notes on safety
DANGER
Risk of injury!
 Always apply the safety rod when the
waste container is raised.
 Perform the safeguarding only from
outside the hazard zone.
1 Holder of safety rod
2 Safety rod
 Fold the safety rod for the high empty-
ing up and insert it into the holder (se-
cured).
Please do not release engine
oil, fuel oil, diesel and petrol
into the environment. Protect
the ground and dispose of used
oil in an environmentally-clean
manner.
Safety notes regarding the batteries
Please observe the following warning notes
when handling batteries:
Observe the directions on the
battery, in the instructions for
use and in the vehicle operat-
ing instructions!
Wear an eye shield!
Keep away children from acid
and batteries!