Operation; Operation Without External Control; Sound Control; Automatic Mode - EuroLite LED KLS-5050 Bedienungsanleitung

7. OPERATION

After connecting the unit to the mains it requires a short initialization process and is then ready for operation.
It may be controlled via DMX controller or a foot pedal. Alternatively, it can be operated without external
control in sound-controlled mode or in automatic mode with processor-controlled color changes. The
operating modes can be selected by means of the display and the control buttons. After switching the light
set off and on again, the operating mode selected last is activated.

7.1 Operation without external control

Sound control

1
Via the microphone, which is integrated in the control unit, the rhythm of the music (sufficient bass
provided) can be perfectly reproduced by the light set. To select sound control press the button MENU
so many times until
2
Adjust the microphone sensitivity to the volume of the music with the control SENSIVITY. If the volume
of the music is changed afterwards, the microphone sensitivity must be readjusted accordingly.

Automatic mode

1
To select the automatic mode with processor-controlled color changes, press the button so many times
until is indicated in the display.
2
Once again, press the button MENU to select menu item speed
to adjust the desired speed in automatic mode from high (S 01) to low (S 100).

Master/slave operation with several light sets

1
When several light sets are interconnected ( 6.4), the slave units can be synchronized and controlled
with the master unit. For this select the desired operating mode (music control or automatic mode) at
the master unit and set each slave unit to the DMX starting address
each slave unit to the DMX operating mode. The display will indicate
sets will now operate in sync.
2
When the master unit is to be controlled with the foot pedal FP-1, also select the operating mode music
control or automatic mode and set each slave unit to the DMX starting address
each slave unit to the DMX operating mode. The interconnected light sets can now be operated in sync
with the foot pedal.

7.2 Remote control with the foot pedal FP-1

The foot pedal available as accessory allows convenient control of the light set.
1
Press pedal 1 PRESETS repeatedly for the desired function. One in seven preset colors or color
change and color fade of the colors can be selected.
Number
1
2
3
4
5
6
7
8
9
2
Press pedal 2 SOUND CONTROL to select sound control.
3
Press pedal 3 FREEZE to select the freeze function. Then the current color is kept.
4
Press pedal 4 BLACK OUT to switch off all LEDs.
5
After switching the light set off and on again, the function selected last is activated.
is indicated in the display.
Function
white
red
green
blue
cyan
yellow
purple
color change every second
color fade every 3 seconds
27/32
. Use the buttons UP and DOWN
( 7.3). Finally, switch
and the interconnected light
. Finally, switch
00069277.DOC, Version 1.0