Programming Of Lm Og (Cnd) And Lm Og-Hf (Cnd) - Badger Meter LM OG Serie Bedienungsanleitung

PROGRAMMING OF LM OG (CND) AND LM OG-HF (CND)

Measuring unit
TOTAL resettable (Keep TOTAL pressed,
then pressed, then press RESET)
TOTAL not resettable
Press TOTAL one time to switch on
the meter .
Press TOTAL 3 times then press RESET 3
times (quickly) to access the programming
mode . Measuring unit "L" (liter) is flashing
and can be changed in L, GAL, QT or PT by
pressing RESET . Press TOTAL to confirm the
new measuring unit .
Press TOTAL one time to change the
k-factor .
The figure to be changed is flashing and can
be modified with RESET .
To change the next figure, press TOTAL .
The second figure can now be changed .
To access the next figure, press TOTAL .
The third figure can now be changed .
To access the next figure, press TOTAL .
April/April/Avril 2023
Bedienungsanleitung / User Manual / Manuel d´installation
AUT-UM-03446-DE-02
The fourth figure can now be changed .
To access the next figure, press TOTAL .
The fifth figure can now be changed .
Press both buttons simultaneously to save
the programming .
The meter then goes to the sleeping mode .
Sleeping mode
After the sleeping mode, press TOTAL to
show the normal display mode .
Press RESET for 3 seconds and the register
displays the checksum .
Seite / Page / Page 17