Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
LM OG Baureihe / LM OG Series / Série LM OG
DISCLAIMER
The user/purchaser is expected to read and understand the information provided in this manual, follow any listed safety
precautions and instructions and keep this manual with the equipment for future reference . The information in this manual
has been carefully checked and is believed to be entirely reliable and consistent with the product described . However, no
responsibility is assumed for inaccuracies, nor does Badger Meter, Inc . assume any liability arising out of the application
and use of the equipment described . Should the equipment be used in a manner not specified by Badger Meter, Inc ., the
protection provided by the equipment may be impaired and the warranty voided .
BASIC SAFETY RECOMMENDATIONS
Before installing or using this product, please read this instruction manual thoroughly . Only qualified personnel should install
and/or repair this product . If a fault appears, contact your distributor .
Installation
•
Do not place any unit on an unstable surface that may allow it to fall .
•
Never place the units above a radiator or heating unit .
•
Route all cabling away from potential hazards .
•
Isolate from the mains before removing any covers .
•
Max . torque for meters with PVC housing is 8 Nm!
Power Connection
Use only the type of power source suitable for electronic equipment . If in doubt, contact your distributor . Ensure that any
power cables are of a sufficiently high current rating . All units must be earthed to eliminate risk of electric shock . Failure to
properly earth a unit may cause damage to that unit or data stored within it .
Protection Class
Following devices have protection class IP 42:
•
LM OG-PK
•
LM OG-RFK
•
LM OG-T100
•
LM OG-T200
•
LM OG-TK 100
Following devices have protection class IP 65:
•
LM OG
•
LM OG-CND
•
LM OG-K
•
LM OG-CNDK
•
LM OG-HF
•
LM OG-HF-CND
•
LM OG-HFT
All devices have to be protected against dripping water, water, oils, etc .
Setup & Operation
Adjust only those controls that are covered by the operating instructions . Improper adjustment of other controls may result in
damage, incorrect operation or loss of data .
Seite / Page / Page 14
•
LM OG-AM
•
LM OG-CDAM
•
LM OG-CNDAM
•
LM OG-TAERKM
•
LM OG-TAERM 200
•
LM OG-P2 Advanced
AUT-UM-03446-DE-02
April/April/Avril 2023
Werbung
Inhaltsverzeichnis
