Connection Of The Appliance - KKT KOLBE EB9105ED Benutzerhandbuch

Installation

Connection of the appliance

The appliance must be connected in accordance
!
with the rules currently.
It can only be handled by an authorized electri-
cal installer if in force.
Important: Unplug your oven before performing
installation or maintenance!
Warning: This appliance must be earthed
• The electrical safety of the appliance can only be
guaranteed if it has been correctly connected to an
efficient earthed power supply, as laid down in the regu-
lations for electrical safety.
• The manufacturer cannot be held responsible for any
damage to persons or objects due to lack of an earth
connection.
• Check that the power rating of the mains supply and of
the sockets are suitable for the maximum power of the
appliance as indicated on the specification plate.
• The plug should be accessible after installation. Fit the
plug into an outlet with a third contact corresponding to
the ground connection. This must be carefully combined.
• If the appliance is just fitted with supply leads but does
not come already fitted with a plug, then permanently
connect it to fixed wiring as follows:
The "yellow/green" earth wire, which must be con-
nected to the terminal, has to be about 10mm longer
than the other wires; the "blue" neutral wire has to be
connected to the terminal marked with letter N.
"Black, brown, red" live wires have to be connected to
terminal L.
• Mains connection can also be made by fitting a double
pole switch with a minimum gap between the contacts
of 3mm, proportionate to the load and complying with
the regulations in force.
• The yellow/green earth wire should not be controlled
by the switch.
• The plug or a double pole switch used for mains supply
connection should be easy to get at, once the appliance
is in position.
• Important: Position the mains supply cable so that it is
never subjected to a temperature which is more than
50°C above the ambient temperature.
53