Ec Declaration Of Conformity; Mains Connection; Maintenance - AEG Powertools TS 55 E Originalbetriebsanleitung

SpEcIfIED conDItIonS of uSE
The plungecut circular saw can be used for sawing solid wood,
bonded wood, glued veneer, materials similar to wood, plaster and
cement-bonded fibre materials, aluminium profiles, Non-ferrous
metals and plastics.
Do not use this product in any other way as stated for normal use.
Ec-DEclaratIon of conformIty
We declare under our sole responsibility that this product is in
conformity with the following standards or standardized documents.
EN 60745, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3,
in accordance with the regulations 2006/42/EC, 2004/108/EC
Winnenden, 2010-10-25

maInS connEctIon

Connect only to single-phase AC current and only to the
system voltage indicated on the rating plate. It is also possible
to connect to sockets without an earthing contact as the design
conforms to safety class II.

maIntEnancE

The ventilation slots of the machine must be kept clear at all times.
Clean only with dry cloth. Certain cleaning agents and solvents are
harmful to plastics and other insulated parts. Keep the apparatus
handle clean, dry and free of oil or grease.
Use only AEG accessories and spare parts. Should components need to
be replaced which have not been described, please contact one of our
AEG service agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state
the Article No. as well as the machine type printed on the label
and order the drawing at your local service agents or directly at:
AEG Elektrowerkzeuge, Max-Eyth-Straße 10, D-71364 Winnenden,
Germany.
Rainer Kumpf
Manager Product Development
Authorized to compile the technical file
SymBolS
Please read the instructions carefully before starting
the machine.
CAUTION! WARNING! DANGER!
The dust produced when using this tool may be harmful
to health. Do not inhale the dust. Wear a suitable dust
protection mask.
Always wear goggles when using the machine.
Always disconnect the plug from the socket before
carrying out any work on the machine.
Accessory - Not included in standard equipment,
available as an accessory.
Solid wood (hard, soft), chipboards and hard fibre
boards, laminated wood, blockboards, veneered and
coated boards
Plastics, fibre-reinforced plastics paper and fabric acrylic
glass
Plaster and cement-bonded fibre boards
Aluminium panels and profiles up to 15 mm
Do not dispose of electric tools together with household
waste material! In observance of European Directive
2002/96/EC on waste electrical and electronic
equipment and its implementation in accordance with
national law, electric tools that have reached the end of
their life must be collected separately and returned to
an environmentally compatible recycling facility.
GB
English
17