Inhaltsverzeichnis
Werbung
w
q
t
Sewing Buttons
e
q Pattern selector:
w Presser foot:
e Thread tension:
r Stitch length:
r
t Darning plate
Attach the darning plate. Match the holes in the
button with the horizontal slot on the presser foot.
Adjust the stitch width matching the distance of
the holes in the button. Lower the foot to hold the
button in place. Check to see if the needle enters
into the holes in the button by turning the
handwheel by hand. Sew about ten (10) stitches.
To strengthen the shank, cut the threads
leaving about 4.0˝ (10.0 cm). Bring the needle
thread down through one of the holes in the
button and wind it around the shank. Bring the
needle thread to the wrong side (bottom side) and
knot.
After button sewing is completed, remove the
darning plate.
34
C
Zigzag foot
3–7
Any
Werbung
Inhaltsverzeichnis
