Inhaltsverzeichnis
Werbung
q
q
w
q
e
w
q
w
e
e
Presser Foot Lifter
The presser foot lifter raises and lowers your
presser foot.
You can raise it about 0.6 cm (1/4˝) higher than
the normal up position for easy removal of the
presser foot or to help you to place heavy fabric
under the foot.
q Lowest position
w Normal up position
e Highest position
Changing Presser Foot
q Presser foot
w Groove
e Pin
CAUTION:
When attaching or removing presser foot, turn
OFF the power switch.
• To remove
Turn the handwheel toward you to raise the
needle bar to its highest position.
Raise the presser foot.
Push the toe of the presser foot q to snap it off
the foot holder.
• To attach
Place the presser foot so that the pin e on the
foot lines up directly below the groove
foot holder. Lower the foot holder to lock the foot
in place.
To Attach and Remove the Foot Holder
q Thumb screw
w Foot holder
e Presser bar
• To remove
Remove the thumb screw
counterclockwise with a screwdriver.
• To attach
Match the hole in the foot holder w with the
threaded hole in the presser bar e. Fit the
thumb screw q into the hole. Tighten the screw
q by turning it clockwise with screwdriver.
10
of the
w
by turning it
q
Werbung
Inhaltsverzeichnis
