Endpoint Criterion; Measurement Status; Dual Channel Operation - Mettler Toledo SevenDirect SD23 Benutzerhandbuch

To interrupt an analysis, proceed as follows:
1 Tap Terminate.
2 Confirm with OK to go back to Home screen.
- or -
Tap Cancel to continue the analysis.

5.7 Endpoint criterion

The measurement will stop based on the setting in Methods > Measure > Endpoint type.
If Endpoint type is defined as:
Automatic: The measurement will stop automatically, based on the programmed stability criteria.
Manual: The measurement will only stop when you tap Manual endpoint.
Timed: The measurement will stop after the defined time in Methods > Measure > Endpoint time.
If Home screen > Menu > Settings > Analysis settings > Allow taking of manual endpoint is active, you can
also stop the measurement manually by tapping Manual endpoint during the measurement, whatever the
Endpoint type is defined for.

5.8 Measurement status

Measurement Reading
Measurement
limit
Inactive
Active
Temperature Reading
Temperature
limit
Inactive
Active

5.9 Dual channel operation

SevenDirect™ SD23
In progress
Within limit Out of limit
font: light blue
background: white
font: light blue font: red
background: white
In progress
Within limit Out of limit
font: light blue
background: white
font: light blue font: red
background: white
Endpoint reached
Within limit Out of limit
font: white
background: dark blue background: light
blue
font: white
background: green background: red
Endpoint reached
Within limit Out of limit
font: white
background: dark blue background: light
blue
font: white
background: green background: red
17