Mettler Toledo SevenDirect SD23 Benutzerhandbuch Seite 18

# Description
1 Method ID
2 Duration
3 Temperature
4 Endpoint type
8
Function
Tap on the different tabs to switch between the measurement modes.
'pH:': can perform pH measurement, pH sensor calibration and pH
sensor verification
'Cond.:': can perform conductivity measurement, conductivity sensor
calibration and conductivity sensor verification
'pH & Cond.': can perform simultaneous pH and conductivity
measurements
'Redox:': can perform redox measurement and redox sensor verification
'Redox & Cond.': can perform simultaneous redox and conductivity
measurements
: displays the duration of the measurement.
: displays the number of data points which are already recorded.
Only if Methods > Measure > Interval reading is active, you can tap to
switch between these 2 modes.
Displays the temperature.
Tap to perform a temperature check while the meter is in idle state.
: gets the temperature value from the sample automatically.
: taps to change the temperature value used for the current
measurement only.
Displays the information of the endpoint type.
If a user belonging to the Administrator user group is logged in, you can tap
to enter the active method to adjust settings for the endpoint type and the
stability criterion.
1. Endpoint type, defined in Methods > Measure > Endpoint type.
Automatic: stops the measurement automatically when the signal
is stable.
Manual: manually stops the measurement by tapping Manual
endpoint.
Timed: stops the measurement after the predefined time.
2. Stability Criterion (pH only), defined in Methods > Measure > Stability
criteria. Details see Stability criteria.
Strict
Standard
Fast
SevenDirect™ SD23