Safety Instruction; Usage - Zendure SmartFlow Bedienungsanleitung

Name
Model
Weight
Dimensions
Capacity
Type
Output Power
Input Power
Max Extend Number of Battery
Max Extend Capacity
IP Level
Color
Charging Temperature
Discharging Temperature
Warranty
Smart PV Hub controller doesn't include a battery pack, and the battery needs
to be purchased separately. For more information about battery AB1000, please
check the user manual of AB1000 .

3. SAFETY INSTRUCTION

3.1 Usage

1. Please check whether SolarFlow is damaged, cracked, liquid leakage, heat or
other abnormalities or cables are damaged before operating. If any, please
stop using the product immediately and contact our customer service.
2. Keep a distance of 50mm between Smart PV Hub and other objects.
3. During the operation of the solar energy system, avoid direct sunlight to
prevent the SolarFlow system from overheating. Do not place the SolarFlow
near any heat source.
4. Do not use around strong static electricity or magnetic fields.
5. It is prohibited to place the equipment in an environment with flammable,
explosive gas, or smoke. Since SolarFlow relies on the shell to dissipate heat,
over-temperature of the shell will lead to damage.
6. Do not attempt to replace the internal components of the equipment by any
unauthorized personnel.
7. Please install the product according to our user manual to avoid damage to
the product or injury to other people.
8. Ensure before finishing installation, the solar cable, the Microinverter canle to
home grid are disconnected.
9. Ensure that Smart PV Hub and Microinverter are installed firmly to avoid
accidents and product damage caused by dropping.
10. SolarFlow has a protection level of IP65, so the product cannot be immersed
in liquids. If the product accidentally falls into water during use, please place
it in a safe and open area and keep it away until it is completely dry. The
dried product should not be used again and should be properly disposed of
according to the disposal guidelines in this manual.
11. Please ensure proper ventilation while in use, inadequate ventilation may
cause permanent damage to the equipment.
12. Do not place anything on the top of SolarFlow, please install it where people
cannot touch it.
Add-on Battery AB1000
ZDAB1000
≈ 11.5kg
350×200×186.5mm
960Wh/48V
LiFePO4
1,200W Max
800W Max
4
3,840Wh
IP65
Gray
0-45℃
-20-45℃
10 Years
EN
3