Energiesparmodus (Nur Bei Gerätemodellen Srk-Zsx-Wf) - S-Klima S-Serie Technisches Handbuch

When the air-conditioner is stopped in SLEEP or OFF TIMER operation during ECONOMY operation.
When the operation is retrieved from CLEAN or ALLERGEN CLEAR operation.
(b) Content of control
(b) When the following operation are set, ECONOMY operation will be canceled.
Fernbedienungen installieren (i) If the outdoor air temperature sensor (TH2 (Tho-A)) detects below 5°C, the indoor unit speed is switched to 9th
When the HI POWER/ECONO button is pressed again.
step. (It is not possible to change.)
When the operation mode is changed DRY to FAN.
(ii) If the outdoor air temperature sensor (TH2 (Tho-A)) detects higher than A°C, the indoor unit speed is changed to
(c) Not operable while the air-conditioner is OFF.
the normal control speed.
(d)
Temperatur-
anpassung
(6) High power operation
bei Betriebsstart.
Pressing the HI POWER/ECONO button intensifies the operating power and initiates powerful cooling and heating
eine Stunde nach Betriebsstart
operation for 15 minutes continuously. The wireless remote control displays and the FAN SPEED display disappears.
zwei Stunden nach Betriebsstart.
(a) During the HIGH POWER operation, the room temperature is not controlled. When it causes an excessive cooling and
Kühlbetrieb
heating, press the HI POWER/ECONO button again to cancel the HIGH POWER operation.
(b) HIGH POWER operation is not available during dehumidifying and the program timer operations.
+0.5
(c) When HIGH POWER operation is set after ON TIMER operation, HIGH POWER operation will start from the set time.
(d) When the following operation are set, HIGH POWER operation will be cancelled.
0
When the HI POWER/ECONO button is pressed again.
-0.5
When the operation mode is changed.
When it has been 15 minutes since HIGH POWER operation has started.
(e) Not operable while the air-conditioner is OFF.
(f) After HIGH POWER operation, the sound of refrigerant flowing may be heard.
Kanalgeräte SRR-ZS-W / Truhengerät SRF-ZS-W, SRF-ZSX-W
(8) Air flow direction adjustment
(a) Flap
(Flap stopped)
Angle of Flap from Horizontal
W
Remote control
display
COOL , DRY, FAN
(d) The setting temperature is adjusted according to the following table. N
HEAT
(d) Die eingestellte Temperatur wird wie in der folgenden Tabelle angepasst.
Mode
Item
(b) Louver
Betriebs-
Kühlbetrieb
Temperature
Einstellung art
adjustment
①＋0.5
Temperatur -
②＋1.0
anpassung
③＋1.5
at the start of operation.
(Louver stopped)
one hour after the start of operation.
bei Betriebsstart.
two hours after the start of operation.
eine Stunde nach Betriebsstart
zwei Stunden nach Betriebsstart.
(Swing)
Angle of Louver
12.10.1 Energiesparmodus (nur bei Gerätemodellen SRK-ZSX-WF)
Remote control
display
●
Bei Betätigung der Taste [HI/ECO] wird ein Soft-Betrieb mit unterdrückter Leistung gestartet,
um eine übermäßige Kühl- oder Heizleistung zu vermeiden.
Center installation
Auf der Fernbedienungsanzeige erscheint
Right end installation
Left end installation
(c) Swing
270
1)
ON
(Einheit: )
OFF
He
5 17
Outdoor air temperature (℃)
Abb. A Abb. B
40 50 60
Feuchte (%)
Abb. A
U/D
U/D
Approx. 5° Approx. 20°
Approx. 20° Approx. 35°
Cooling Heating
(Einheit: )
Heizbetrieb
L/R
①－1.0
Figure A Figure B
②－2.0
③－2.5
Left approx. 50° Left approx. 20°
Left approx. 50° Left approx. 45°
38
-
Left approx. 20°
Center
29
-
Technisches Handbuch S-Serie R32 | Ausgabe 11-01-2023 | 20007503
Heizbetrieb
+0.5
0
When the SILENT botton is pressed.
-0.5
When the NIGHT SETBACK botton is pressed.
45
Feuchte
Abb. B
L/R
Approx. 35° Approx. 50°
Approx. 45° Approx. 60°
Center Right approx. 20° Right approx. 50°
.
Left approx. 30° Center
-
Right approx. 30° Right approx. 45° Right approx. 50°
-
2)
50 55
(%)
(Swing)
.
Approx. 70°
Approx. 70°
Right approx. 20°