Energiesparbetrieb Bei Wandgeräten Srk-Zs-Wf/Srk-Zr-Wf/ Kanalgeräten Srr-Zs-W/Truhengeräten Srf-Zs-W, Srf-Zsx-W - S-Klima S-Serie Technisches Handbuch

Jumper wire
(JA3)
Shorted
Shorted
Open
12.10 Energiesparbetrieb bei Wandgeräten SRK-ZS-WF/SRK-ZR-WF/
Open
Kanalgeräten SRR-ZS-W/Truhengeräten SRF-ZS-W, SRF-ZSX-W
Notes: (1) Default states of the jumper wire (JA3) and the interface kit at the shipping from factory – On the
Wandgeräte SRK-ZS-WF, SRK-ZTL-W
PCB, the DIP switch (SW2-4) is set to enable the annual cooling function.
(2) To cancel the annual cooling setting, consult your dealer.
Bei Bestätigung der Taste HI POWER/ECO wird ein Soft-Betrieb mit unterdrückter Leistung gestartet, um eine
(b) Content of control
übeU P ¦ ¡ L ge Kühl- oder Heizleistung zu vermeiden. . . D as Gerät überschreitet die eingestellte Temperatur im
(i) If the outdoor air temperature sensor (TH2 (Tho-A)) detects below 5°C, the
Kühlbetrieb um 1,5 °C und um 2,5 °C im Heizbetrie. b . Auf der kabellosen Fernbedienung wird ECO angezeigt und
indoor fan speed is switched to 8th step. (It is not possible to change.)
FAN SPEED ausgeblendet.
(ii) If the outdoor air temperature sensor (TH2 (Tho-A)) detects higher than 7°C,
the indoor fan speed is changed to the normal control speed.
(a) Das Gerät wechselt in den Economy-Betrieb, wenn die folgenden Bedienungsschritte der Klimaanlage ausgeführt
werden.
High power operation
y ' L H . O L P DDQ O DJ H Z L U G P L W G HU 7 DV W H 2 1 2 ) ) Z ¦ KU HQ G G HV ( FRQ RP \ % HW U L HEV J HV W RSSW
Pressing the HI/ECO button intensifies the operating power and initiates powerful cooling or heating operation for
y ' L H . O L P DDQ O DJ H Z L U G L P 6 / ( ( 3
15 minutes continuously. The wireless remote control displays HIGH POWER mark and the FAN SPEED display disappears.
y ' HU % HW U L HE Z L U G DX V G HU % HW U L HEV DU W 6 ( / ) & / ( $ 1 RG HU $ / / ( 5 * ( 1 & / ( $ 5 Z L HG HU DX IJ HQ RP P HQ
During the HIGH POWER operation, the room temperature is not controlled. When it causes an excessive cooling or heating,
(b) Wenn die folgenden Bedienungsschritte ausgeführt werden, wird der Economy-Betrieb aufgehoben.
press the HI/ECO button again to cancel the HIGH POWER operation.
y ' L H 7 DV W H + , 3 2 : ( 5 ( & O wird erneut gedrückt.
HIGH POWER operation is not available during dehumidifying and the program timer operations.
y ' L H % HW U L HEV DU W Z L U G YRQ ' 5 < DX I ) $ 1 X P J HV FKDO W HW
When HIGH POWER operation is set after setting ON TIMER operation, HIGH POWER operation will start from the set time.
y ' L H 7 DV W H 1 ,* + 7 6 ( 7 % $ & . Z L U G J HG U ¾ FN W
When the following operation are set, HIGH POWER operation will be cancelled.
(c) 1 L FKW IX Q N W L RQ V I¦ KL J Z ¦ KU HQ G G L H . O L P DDQ O DJ H DX V J HV FKDO W HW L V W
① When the HI/ECO button is pressed again. (The operation mode will be changed to the ECONOMY operation.)
(d) Die eingestellte Temperatur wird wie in der folgenden Tabelle angepasst.
② When the operation mode is changed.
③ When it has been 15 minutes since HIGH POWER operation has started.
④ When the 3D AUTO botton is pressed.
Betriebsart
Kühlbetrieb
⑤ When the SILENT botton is pressed.
Einstellung
①＋0.5
⑥ When the NIGHT SETBACK botton is pressed.
Temperatur-
②＋1.0
anpassung
Not operable while the air-conditioner is OFF.
③＋1.5
After HIGH POWER operation, the sound of refrigerant flowing may be heard.
(9) Air flow direction adjustment
Wandgeräte SRK-ZR-WF
Economy operation
Air f low direction can be adjusted with by AIR FLOW
wireless remote control.
(a) Flap
Every time when you press the AIR FLOW
(Flap stopped)
Angle of flap from horizontal
W
Wireless remote
control display
COOL, DRY, FAN
HEAT
(d) The setting temperature is adjusted according to the following table. N
(b) Louver
Mode
Item
Every time when you press the AIR FLOW
Temperature
adjustment
(Louver stopped)
at the start of operation.
one hour after the start of operation.
(Swing)
two hours after the start of operation.
Angle of louver
Wireless remote
control display
Center installation
Technisches Handbuch S-Serie R32 | Ausgabe 11-01-2023 | 20007503
Right end installation
Left end installation
(SC-BIKN2-E)
SW2-4
ON
OFF
ON
OFF
RG HU 2 ) ) 7 ,0 ( 5
(Einheit: )
Heizbetrieb
①－1.0
y EHL % HW U L HEV V W DU W
②－2.0
y HL Q H 6 W X Q G H Q DFK % HW U L HEV V W DU W
③－2.5
y ] Z HL 6 W X Q G HQ Q DFK % HW U L HEV V W DU W
Approx. 25° Approx. 30°
Approx. 25° Approx. 35°
Cooling Heating
28
-
Figure A Figure B
(Spot)
Left approx. 50° Left approx. 20°
Left approx. 50° Left approx. 45°
Left approx. 20° Center
Function
Enabled
factory default setting
Disabled
Disabled
Disabled
% HW U L HE Z ¦ KU HQ G G HV ( FRQ RP \ % HW U L HEV J HV W RSSW
.
.
(UP/DOWN) and (LEFT/RIGHT) button on the
Approx. 40° Approx. 50°
Approx. 50° Approx. 60°
-
(Wide)
Center Right approx. 20°
Left approx. 30° Center
Right approx. 30° Right approx. 45° Right approx. 50°
Fernbedienungen installieren
Jumper wire (J172)
ON
OFF
5 7
Outdoor air temperature ( C)
'09•SRK-DB-087D
(Swing)
.
Approx. 60°
Approx. 70°
Right approx. 50°
Right approx. 20° 269