Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.3 FM radio
1) Press the button MODE repeatedly until
FM radio
is shown on the display The FM
station most recently listened to will be
played or, if the operating mode is called
up for the first time, the first FM reception
frequency possible
FM
12:45
87.50MHz
If the mode is called up for the first time,
all stations must be scanned and saved first
(steps 3 and 4)
2) To change the scan setting: The scan is
factory-set to only stop at stations with
good reception For the automatic scan
to stop at stations with poor reception,
press the button MENU The menu "FM"
will appear:
FM
Scan settin g
Audio settin g
System settin g s
Main menu
The line
will be selected
Scan settin g
Press the knob CONTROL SELECT The fol-
lowing confirmation prompt will appear:
FM station scan
Stron g stations only?
YES*
NO
Turn the knob CONTROL SELECT to select
the setting
and then press the knob
NO
to confirm
3) Station scan: Press the knob CONTROL
SELECT: The scan will start at the frequency
shown and will stop at the first station
(If required, turn the knob CONTROL
SELECT for a fine adjustment of the fre-
quency in 50 kHz increments ) To search
for the next station, press the knob again
To change the direction of the scan, turn
the knob briefly into the direction desired
(left = reverse scan; right = forward scan)
before you start the scan
To start the scan via the remote con-
trol, keep the button I (forward scan)
or I (reverse scan) pressed until the scan
starts
Indication during replay: If the station
broadcasts RDS information (Radio Data
R . D . S
System,
indicated), the display
will show the station name instead of the
frequency (this may take a few minutes)
Some stations also provide information
concerning the programme and /or current
music title Press the button INFO repeat-
edly to show more information The sym-
bols in the lower line have the following
meaning:
Replay in stereo mode
Indication of the signal strength re-
ceived
4) To save a station and to call up a station
saved: The procedure for saving a station
and for calling up a station saved is the
same as in the operating mode "Internet
radio":
5) Replay in mono mode: To reduce the noise
of stations with poor reception, select the
mono mode: Press the button MENU The
menu "FM" will appear on the display
(fig 38) Select and confirm
The following confirmation prompt
tin g
will be shown:
Fig. 37
FM weak reception
Listen in Mono only?
YES
Select and confirm the setting
all stations will be replayed in mono mode
>
>
>
Fig. 38
Fig. 39
☞
steps 4 and 5 in chapter 4 1
Audio set
NO*
Fig. 40
YES
4.4 Music player
The music player is able to replay audio files in
the formats MP3, AAC /AAC+, WMA, WAV or
FLAC from a USB storage medium (USB flash
drive or USB hard disk) or from a unit in the
local network (e g computer)
Note: Due to the large number of storage device
manufacturers and device drivers, it cannot be
guaranteed that all storage media are compatible
with the music player
Press the button MODE repeatedly until
appears on the display Then,
Music player
the menu "Music player" will appear:
Music player
Shared media
USB playback
My playlist
Repeat play: Off
Shuffle play: Off
Then
4.4.1 Replay via the USB connection
1) Connect a USB flash drive or a hard disk
to the USB port When a USB storage
medium is connected to the port, the fol-
lowing confirmation prompt will appear:
USB playback
USB disk attached
Open folder?
YES
is selected To call up the USB stor-
YES
age medium, press the knob CONTROL
SELECT
Note: This confirmation prompt will also be
shown when the unit is in a different operating
mode The unit will go to the operating mode
"Music player" after the prompt has been con-
firmed
As an alternative, a USB storage medium
can also be called up via the menu "Music
player": Turn the knob CONTROL SELECT
to select the line
press the knob to confirm
2) Once the USB storage medium has been
called up, the contents of the medium are
shown:
USB playback
Blues
Country
POP
Beat Machine Come...
DoMan Go!
Turn the knob CONTROL SELECT to select
a title and then press the knob to start
the replay To select a title from a folder
(indicated by
), first turn the knob to se-
>
lect the folder and then press the knob to
call it up In the folder, select and replay
the title desired
3) To return to the previous selection level
in the menu, turn the knob CONTROL
SELECT or press the button BACK (with
the remote control: press the button
or
) From this level, it is possible to
select a different title or, by means of the
button BACK or
the menu
An overview of the operating functions
and displays can be found in chapter 4 4 4
>
>
Fig. 41
NO
Fig. 42
USB playback
and then
>
>
>
Fig. 43
,
, to go back further in
23
Werbung
Inhaltsverzeichnis
