Parkside PSHL 2 D1 Originalbetriebsanleitung Seite 26

and by persons with reduced physical, sensory or mental capaci-
ties, or a lack of experience and knowledge, if they are supervi-
sed or have been instructed in how to use the device safely and
understand the dangers that may arise when using it. Do not allow
children to play with the device. Cleaning and day-to-day mainte-
nance must not be performed by children without supervision.
The welding helmet with auto-darkening is not suitable for laser
„
and autogenous welding.
Never place the welding helmet on hot surfaces.
„
Do not open the welding helmet under any circumstances. Do not
„
carry out any repair work or alterations to the welding helmet. This
work must only be carried out by trained specialist personnel.
Before any welding work, please make sure that you have adjus-
„
ted the auto-darkening.
The safety visor must not be opened. It protects the filter from dirt
„
and damage.
If the filter does not darken automatically, stop the welding work
„
immediately and contact the manufacturer.
Only use the welding helmet at temperatures between -5°C and
„
+55°C.
The response time of the filter will slow down if the temperatures
go below/above these temperatures.
Clean the filter, helmet surface and the solar cells regularly.
„
Replace the protective visor if it showing signs of scratches or da-
„
mage.
The welding helmet does not protect against impact.
„
Using, cleaning and storage can reduce the service life of approx.
„
5 years. If the viewing pane is scratched or there is other visible
damage to the viewing pane or the welding helmet, replace imme-
diately.
ATTENTION! Materials which come into contact with the skin of
the wearer can cause allergic reactions for sensitive individuals.
ATTENTION! Eye protection equipment against high-speed par-
ticles can pose a danger for the wearer through transfer of impact if
they are worn over standard prescription glasses.
ATTENTION! If protection against high-speed particles at extreme
temperatures is necessary, the selected eye protection equipment must
be marked with the letter T in accordance with the letters relating to
impact intensity, i.e. FT, BT or AT. If the letter for impact intensity is not
followed with the letter T, the eye protection equipment must only be
used at room temperature against high-speed particles.
26
GB