Troubleshooting - Cub Cadet D20 Bedienungsanleitung

Troubleshooting

Risk of injuries or material damage
In case of doubt always consult a specialist workshop.
Shut the device down prior to all checks and all work on the cutting blades.
Protect yourself against injury by doing the following prior to all work on the device:
-
- remove the safety key
- engage the parking brake
- wait until all rotating parts have come to a standstill
- wait until the device has cooled down (approx. 15 minutes).
Problem
Device cannot be switched
on.
Strong vibrations.
Cutter deck does not
discharge grass or cuts
unevenly.
Low travelling speed.
Other error messages / instructions on the LCD display of the control module and what they
mean
Error messages and instructions as symbols
Error message /
Meaning
instruction
Battery temperature tool low: Move the device to a warmer place so that the temperature of
!
the battery can increase.
If the problem persists, refer to a service centre.
!
Battery, drive motor or cutter deck motor too high:
!
again. If the problem persists, refer to a service centre.
Battery charger charging cable is inserted into the charging socket.
Prior to switching on the device, the charging cable must be removed and the cover of the
charging socket must be shut.
Troubleshooting
WARNING!
Possible cause
Safety locking system has actuated.
Damaged blade shaft or defective cutter.
Device overloaded and cutter deck has
Travelling speed too high.
Cutting blade is blunt.
Low power pack charge status.
Low power pack charge status.
Device overloaded.
Remedy
Sit on the driver's seat. Depress the
brake pedal fully and activate the parking
brake.
Switch the device on again.
See the section "Switching the device
on" and follow all the instructions.
starting process. If the fault remains,
seek a service centre.
Have defective parts replaced in a ser-
vice centre.
Allow the device to cool down and set
the cutter deck higher for mowing.
Reduce travelling speed.
Have the cutting blades sharpened or
replaced by a service centre.
Charge power pack.
Charge power pack.
Set the cutter deck higher for mowing.
EN
27