Cub Cadet D20 Bedienungsanleitung Seite 14

EN
Information about vibrations and noise
Vibrations can cause nerve damage and
impair the blood circulation in the hands and
arms.
When working in the cold, wear warm clothing
and keep your hands warm and dry.
Take breaks.
or hands goes numb, tingles, hurts or goes
white, stop working with the machine and, if
necessary, consult a doctor.
Wear appropriate hearing protection. Work-
ing without ear protection may result in loss of
hearing.
values:
• Were measured according to a standardised
testing procedure.
• Make it possible to estimate the power tool
power tools. Dependent on the conditions of
use, the state of the power tool or tools inserted
for use with it, the actual vibration load may be
higher or lower. When estimating the emis-
sions, consider doing so during work pauses
and phases when the tool is under reduced
load. Based on the correspondingly adjusted
estimated values, take protective actions, e.g.
organisational actions.
Mowing on steep slopes
Do not mow or drive on slopes with an incline
greater than 20 %.
Always mow up and down slopes and not
across them. Do not turn on slopes. Working
on slopes is dangerous. The device could tip or
skid.
Always drive on slopes as gently as possible
and brake carefully. When descending, keep
the device switched on and drive slowly. Exercise
particular caution when changing direction.
Do not use any optionally available grass
catchers on slopes with an incline greater
than 14%.
Do not use any heavy attachment devices on
slopes of more than 9%, such as transport
trailers or lawn rollers.
If operating with an attached trailer, do not
exceed the following maximum values:
Max. support load on the trailer coupling:
22 kg
max. trailer load (trailer and cargo): 110 kg
14
Safety information
After use
If you leave the seat of the device, always turn
and engage the parking brake.
Allow the device to cool down (approx.
15 minutes) before storing it.
Before carrying out any work on the mower
Protect yourself against injury by doing the
following prior to all work on the device:
-
- remove the safety key
- engage the parking brake
- wait until all rotating parts have come to a stand-
still
- wait until the device has cooled down (approx.
15 minutes)
General safety information
Spare parts and accessories must satisfy the
manufacturer. Always observe the installation
instructions supplied with the parts during re-
placement. The use of spare parts or accessories
not approved by the manufacturer can represent
Have repairs performed exclusively by a
cialist workshop addresses can be found on our
website.
Do not carry passengers on the device. The
device is not approved for passenger transport.
Safety information
Always remove the safety key
-
Spe-