Storage; Transport - Cub Cadet D20 Bedienungsanleitung

EN
Adjusting the height of the cutting
mechanism
Bring the cutting mechanism into the highest
height position.
Carefully turn the outer cutters transverse to the
drive direction.
Measure the distance between the ground and the
ends of the two outer cutters.
If necessary, you can adjust the correct distance as
follows. Perform the adjustment on the adjustment
segment [A] on the left and right side of the cutting
mechanism:
Release the lock nuts
To set the level, turn the adjusting nut
Tighten the lock nut again.
(Tightening torque = 34–40 Nm)

Storage

Attention!
Allow the device to cool outdoors prior to stor-
age.
terials (e.g. clothing, wood or chemicals), naked
naces, water heaters or other types of heating
devices).
prior to storage.
Store the device in a clean, dry, enclosed space
(recommended storage temperature approx.
0°C–23°C).
Protect the device from rust when storing it for
lengthy periods of time.
Protect the device from frost.
Clean the device and the grass catcher.
Wipe all metal parts down with a lubricated cloth
to protect them from rust.
cations.
Charge the power pack before and after storage
of the device (even out of season).
Note
50% charge status when going into storage.
26
.
.
-
-
-

Transport

Note
oughfares in accordance with national road
legislation (StVO).
Short distances
highest position before driving the device.
Drive the device only short distances to change its
location of use.
Long distances
WARNING!
Danger posed by unstable and unsecured
ramps
Risk of serious injury to people and sever
damage to property
If you are pushing the device onto a
the ramp is stable and secure.
WARNING!
Danger posed by inadequate fastening
Turbulence during transport
If you are transporting the device in
a trailer or lorry, fasten and secure it
Allow the device to cool.
Transport the device on a transport vehicle over
long distances.
transport vehicle.
Apply the parking brake and secure the device
for example.
Storage
-