Adjusting The Cutting Height - Cub Cadet D20 Bedienungsanleitung

Operation
control module
or
press the accelerator pedal
or
actuate the brake pedal.
Stopping the device
Step on the brake pedal [L] until the device comes
to a standstill.
Note
the same time.
If the device is still moving with the brake pedal fully
pressed down or with the parking brake engaged:
Discontinue use of the device and contact a ser-
vice centre.
Switching the cutter deck on/off
Switching on
The PTO switch [G] switches the cutter deck for the
Switch the device on.
To switch on the cutter deck, press the PTO
switch [C] downwards for approx. 2 seconds and
then release it.
The cutter deck is switched on and a green light
lights up around the PTO switch.
PTO switch [G] downwards for one second and
then release it.
The green light around the PTO switch goes out
Note
locking system.

Adjusting the cutting height

[C] on the To set the cutting height, press the cutting height
adjustment lever [1].
Note
"4" is the highest possible cutting height
located right at the top.
"Lo/1" is the smallest cutting height (ap-
located right at the bottom.
C or D.
Note
is equipped with an adjustable position
indicator [2]
cutting height more quickly.
Mowing
If a foreign object (like a stone) comes into con-
tact with the cutting mechanism, or if the device
immediately.
Inspect the device for damage before continuing
operation. In the event of damage, discontinue
use of the device and have it repaired by a ser-
vice centre prior to putting back into operation.
Do not activate the cutter deck in high grass.
Do not mow any grass that is too long or very
dry grass and do not drive over collections of dry
leaves with the cutter deck activated, because
due to collections of very dry dirt and mowing
residues.
-
Switch the device on.
Switch the cutter deck on and then lower it.
Release the parking brake.
The device moves forwards and mows.
CAUTION!
Risk of injury
Only empty the grass catcher (mod-
Only operate the device with an attached
attached grass catcher.
Attention!
EN
21