Cub Cadet D20 Bedienungsanleitung Seite 20

EN
Engaging / disengaging the parking
brake
To engage the parking brake, step down fully on
the brake pedal [L] and press the switch
To disengage the parking brake, step on the brake
pedal [L] until the switch
Attention!
Always switch on the parking brake before leav-
ing the device.
Turning on the device (put the device into
operating mode)
Remove the battery charger (if connected) and
shut the cover of the charging socket on the de-
vice (if opened).
Sit down on the driver's seat.
Apply the parking brake or press down fully on the
brake pedal.
Insert the safety key into the control module up to
the stop.
indicating that the device can be turned on.
and then release it.
There are two beep sounds and the device is
turned on.
Note
If the connection cable of the battery charger
display.
Note
The following indicators appear on the LCD
display:
— Charge status of the power pack in per
— Charge status with bars shown in the
power pack symbol (each bar representing
around 20%)
e.g.
— operating hours performed
Turning off the device (putting the device into
off mode)
and then release it.
There is one beep sound and the device is turned
or
Pull the safety key out of the control module.
20
Driving
.
is released.
-
Driving with cruise control
Switching the cruise control on
WARNING!
Risk posed by abrupt starting, sudden
stopping and driving at an excessively high
speed.
Risk of accidents
Drive slowly and brake slowly.
Do not drive at excessive speed.
Never change the direction of travel with-
Never make adjustments to the device
while the device is moving.
Switch the device on.
Release the parking brake and release the brake
pedal.
To drive away, step on the
accelerator pedal [C] or
The device moves forwards.
Note
The further you step on the accelerator ped-
Note
tomatically goes back to the starting position
comes to a stop.
Note
must not step on the brake pedal.
Press the cruise control switch [C] on the control
module while driving for approx. 2 seconds and
then release it.
The symbol is shown on the LCD display of the
control module.
The forward speed selected at this point (but not
top speed) is maintained.
Note
Operation
[D].
-
(model-specific)